Arlington Height - Elk Grove Village - Schaumburg - Naperville - Barrington - Crystal Lake - Mundelein

Did you Know?
While major appliances make our lives much easier, they also pose significant risks if not maintained properly. The average homeowner has several thousand dollars invested in major appliances. To protect your investment and ensure many years of reliable service out of each it's important to properly maintain your appliances.

Extension Cords
Extension cords pose several risks. First, the extension cord connections may not be secure. Besides causing power fluctuations that may damage the equipment, poor connections can also result in sparks that could start a fire.

Another problem with the appliance connections is that they are vulnerable to water penetration. This is especially true in damp areas such as laundry rooms, bathrooms, kitchens, garages and outdoors. Water and electricity are a dangerous combination responsible for many avoidable deaths each year.
People often make the mistake of using extension cords that are too small. The wires on extension cords are rated according to size, with lower ratings corresponding to larger sizes. A simple household extension cord for a lamp might have 16-gauge wire. An outdoor cord may have 14-gauge wire. Heavy-duty cords are usually 12-gauge.

In general, in those circumstances where use of an extension cord is unavoidable, employ one that is heavier than the wires already attached to the appliance.
Also, whenever using power tools or similar equipment on long extension cords, be aware that the longer the cord the more power that is lost en route. This phenomenon, called voltage drop, is much less pronounced in heavier wires. Whenever you use an inadequate cord, you run the risk of damaging the appliance or causing the wires to overheat and become a fire hazard.

When extension cords, appliance wires and outlets are incompatible, people often use adapters to make things fit. Most commonly, people have a three-prong plug and a two-prong outlet. The third prong is the ground, and it offers important safety advantages. A much better long-run solution is to have an electrician replace your 2-prong outlets with properly grounded three-prong outlets.

Heavy-duty appliances have plug configurations that are unique. Never use an adapter to fit these into more standard outlet.

Circuit Breakers and Fuses
Older homes have fuse boxes while most new ones have circuit breakers. Both perform the same function. Whenever a short circuit or overload situation occurs, the device shuts off electricity to that circuit, preventing both shocks and fire hazards.
Whenever an appliance stops working, first test the outlet with a lamp or radio. If the circuit is dead, turn off anything you know to be on the same circuit and go to your electrical box, usually located in the basement. If you have a circuit breaker, look for the one switch that is slightly out of alignment. Turn it off and turn it back on again. If you have a fuse box, replace the burnt-out fuse.
If you try the appliance again and the circuit cuts off a second time, you may be overloading that circuit. Try the appliance in another part of the house. If it keeps causing circuits to cut off, something is wrong with the appliance. It may, for instance, have a short.

Pilot Lights
Many older gas appliances (ranges, dryers, water heaters, furnaces, etc.) have pilot lights that run continuously. Newer models have electronic ignition instead.
When an older appliance stops working, check to see if the pilot light has gone out. If it has, re-light it according to the instructions in the manual, which came with the unit or are printed on the appliance itself. In many cases, this will save you the cost of a repair call.
Because pilot lights maintain a flame at all times, they are always ready to ignite any flammable gases that might be present. This is why you should never store paints, solvents and other chemicals anywhere near an appliance with a pilot light.